Inhaltsverzeichnis
Werbung
q
e
t
y
u
w
r
Threading the Needle with the Needle
Threader
The needle clamp can be tilted up for easy threading
(see page 30).
When rethreading, remove the thread from the
needle eye before tilting up the needle clamp.
IMPORTANT:
When tilting up the needle clamp, be sure to:
– turn the power switch off.
– turn the handwheel toward you and match the
alignment marks.
– lower the presser foot.
q Power switch
w Alignment marks
Hold the needle threader with the triangle mark
facing up. Insert the thread into the Y-notch of the
threader from the right.
e Triangle mark
r Y-notch
Slide the threader down along the needle while
pushing it gently until the threader pin goes into
the needle eye.
Place the V-notch over the needle just above the
needle eye.
t V-notch
Push the threader until the threader pin comes out
through the needle eye with a loop of thread.
y Threader pin
Remove the threader from the needle slowly, leaving
the thread loop behind the needle eye.
Using the hook, pull the loop of the thread out
to the back.
u Hook
CAUTION:
Do not turn the hand wheel when the needle clamp is
being tilted up, otherwise it may cause a damage to
the needle clamp.
60
Werbung
Inhaltsverzeichnis
