For Longer Breaks In Operation; Pre-Settings - Sentiotec Cv 31 Montage- Und Gebrauchsanweisung

Instructions for use for the user
7. After automatic mode
Automatic heating mode is always only activated once for safety reasons.
If you want to activate the sauna control unit again with the same settings:
● Press the UP/DOWN buttons
The display
5
or the last set start time.
● Press the PROG/OK
In the display
5
● Press the PROG/OK
The display
5
The indicator light PROGRAM
If you want to reactivate the sauna control unit with modified settings:
see Chapter 7.3.

8.8. For longer breaks in operation

Turn the ON/OFF switch

8.9. Pre-settings

You will receive your control unit with factory pre-sets. The corresponding values
of the functions can be found in the following table:
Sauna mode:
Start of heating
Heating duration
Temperature
Fan
WORLD OF WELLNESS
until the indicator light Start
7
shows: OFF
button once:
8
the automatic start time flashes.
button once:
8
stops flashing.
4
of the control unit off.
1
goes on.
OFF no setting
6 hours
90 °C
60 P
p. 27/34
goes on:
c
EN