Finishing The Installation; Performing Tests - Sentiotec Cv 31 Montage- Und Gebrauchsanweisung

Installation instructions, only for experts

5.7. Finishing the installation

● Screw two cross-head screws into the lower fastening holes
● Ensure that the sauna control unit is fitted securely.
● Place the control panel onto the housing lower part. To do so, insert tabs into
the two lateral holders and press onto the housing lower part until the stop
position.
● Place the housing cover onto the housing lower part, swivel downward and
press until it clicks audibly.

6. Performing tests

The following tests must be performed by a certified electrical fitter.
WARNING!
The following tests must be performed with the power supply
switched on. There is a danger of electric shock.
● NEVER touch live parts.
1. Check the contact of the earth conductors on the earth conductor terminal.
2. Check the excess temperature fuse on the heater sensor F1.
a. Switch on the sauna control unit.
b. Open the heater sensor and disconnect one of the two red wires for
the heater sensor.
► A recurring warning tone sounds, "Err1" appears in the display.
► The control unit switches off the heater.
c. Switch off the sauna control unit.
d. Reconnect the red wire for the heater sensor.
WORLD OF WELLNESS
p. 14/34
(Fig. 2).
5