Entering The Time - Sentiotec Cv 31 Montage- Und Gebrauchsanweisung

Instructions for use for the user p. 20/34

8.5. Entering the time

The sauna control unit is completely disconnected from the mains using the op-
eration switch . The saved settings and the time are retained by an internal
1
battery. After putting the sauna control unit into operation for the first time, the
current time must be set.
1. Switching on the sauna control unit
Press ON/OFF switch :
1
● The indicator lights – go on for approximately 5 seconds.
9 c
● The TIME indicator goes on. (e.g. 12:00): 12:00
d
2. Setting the current time [0–24]
The TIME menu item must be activated: The indicator light goes on.
d
a) Press the PROG/OK button:
8
● In the display flashes: 12:00 or the previously set time.
5
● The display flashes for 20 seconds, and the setting must be started within
5
this time, otherwise setting mode will terminate and it must be selected again.
b) Using the UP/DOWN buttons , set the desired value, e.g. [18:00].
7
c) Press the PROG/OK button:
8
The display stops flashing. The time has been set.
5
WORLD OF WELLNESS