Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
User Manual
MOBILE
Press <B3> (MOBILE) to
enter the PS-mobile
programming menu
MOBILE PROGRAMMING
At the left side of the display
the PS-mobile to be
programmed is shown. Press
<B1> repeatedly to scroll to
the PS-mobile to be
programmed.
Place the selected PS-mobile
in its Charging/storage rack
with its programming switch
(see opposite) set to the
'programming mode' (upper
position).
Press <B5> to 'START' the
programming procedure.The
desk will send the address
along with two operation
codes (Opcode 1 and 2) to
the selected PS-mobile via
the system data lines 1 and 2.
Once the PS-mobile has
been programmed, remove it
from its charging/storage rack
and set the programming
switch back to its original
state corresponding to the
type of batteries used (see
opposite).
PS-Micro control desk LBB 6105/00
SYSTEM menu
SYSTEM
REMOTE
PRINTER MOBILE
G
PROGRAMMING MOBILE
MOB 1
G
Upper position
Middle position
Lower position
PS-mobile 3-position switch
NOTE: To program the PS-mobiles, the system data
lines 1 and 2 need to be connected between the
control desk and the storage racks. Refer to the
Installation Manual of the control desk.
37
28-02-00 16:30
28-02-00 16:30
1 Programming mode
2 non-rechargeable batteries
3 rechargeable batteries
Eng
START
1
2
3
Werbung
Inhaltsverzeichnis
