Philips PS6000 Benutzerhandbuch Seite 24

PS-Micro control desk LBB 6105/00
- Temporary unmanned operation
Acts similar to manned operation. (see also Chapter 8. Unmanned operation).
- Unmanned operation
If set by your system installer, ALL alarms (priority 1, 2 and 3) are transferred immediately
to the 'operator's pager.
5.2.2 Re-routing to COLLEAGUE pager
Each operational channel of the control desk can be programmed to 're-route' a priority 1 or 2
alarm to an assigned 'colleague' pager. Alarms assigned with priority 3 are NOT transferred.The
operational modes for re-routing alarms calls to a 'colleague' pager are as follows:
- Manned operation
If set by your system installer, alarms assigned with priority 1 or 2 are re-routed to the
assigned 'colleague' pager after a set time ('Re-route Delay Time' (0 - 60 seconds)). Check
this setting with your system installer. However, the alarm call will not be re-routed if the
alarm call is acknowledged within the set time.
NOTE: When handling a priority 1 and 2 alarms, the control desk operator can always
're-route an alarm call to a 'colleague' pager manually by pressing the <B4> button (see
chapter 4.3 Reroute).
- Temporary unmanned operation
Acts similar to manned operation. (see also Chapter 8. Unmanned operation).
- Unmanned operation
If set by your system installer, alarms assigned with priority 1and 2 are re-routed
immediately to the 'colleague' pager.
20
User Manual