Philips PS6000 Benutzerhandbuch Seite 32

PS-Micro control desk LBB 6105/00
If the 'No-Move' alarm has
been enabled for GS testing
the following screen is
displayed.
To test the 'No-Move' alarm,
hold the PS-mobile in a
motionless and upright
position for at least 6
seconds. Wait until the alarm
tone is heard. The PS-mobile
will transmit the 'No-Move'
Alarm Call every 6 seconds
to the control desk until
reset. Once received the
control desk displays the
following screen:
If the mobile is programmed in such away that 'NO-MOVE' can only become active is the
mobile is also in a 'NOT-VERTICAL' state, the PS-mobile should be kept motionless in a
horizontal position.
To reset the alarm press the PS-mobiles Alarm/Reset button (<2 seconds).The LED and bleep
confirmation will stop.The 'No-move' alarm reset call will be repeated every 6 seconds.
If the 'Tear-off ' alarm has
been enabled for GS testing,
the following screen is
displayed.
To test the 'Tear-off Alarm'
remove the PS-mobiles
'Tear-off ' plug from its socket.
Wait until the alarm tone is
heard.The PS-mobile will
transmit the "Tear-off Alarm
Call" to the control desk
every 6 seconds until reset.
Once received, the control
desk displays the following
screen:
To reset the 'Tear-off alarm
call replace the 'Tear-off ' plug
onto its socket. The 'Tear-off
reset call will be transmitted
every 6 seconds.
0001
ACTIVATE NO-MOVE ALARM
0001
Alarm received, reset NO-MOVE alarm
0001
ACTIVATE TEAR-OUT ALARM
0001
Alarm received, reset TEAR-OUT alarm
28
User Manual
28-02-00 16:30
28-02-00 16:30
28-02-00 16:30
28-02-00 16:30