Siemens simovert masterdrives Betriebsanleitung Seite 353

04.2006
Automatic
parameterization
and motor
identification
Siemens AG 6SE7087-6KD60
SIMOVERT MASTERDRIVES
The following parameters are calculated or set to fixed values during
automatic parameterization (P115 = 1):
P116 P236
P117 P240
P120 P258
P121 P259
P122 P273
P127 P274
P128 P278
P161 P279
P215 P283
P216 P284
P217 P287
P223 P291
P235 P293
♦ P350 to P354 are only set to the rated motor quantities in the
converter status "Drive setting" (P060 = 5) or "Quick
parameterization (P060 = 3).
♦ In converter status "Drive setting" (but not in "Ready" status),
parameters are assigned automatically on selection of standstill
measurement P115 = 2, 3.
♦ During the standstill measurement P115 = 2, 3, the following
parameters are measured or calculated:
• P103, P120, P121, P122, P127, P347, P349.
The controller settings resulting from these values are in: P283,
P284, P315, P316.
♦ During the rotating measurement P115 = 3, 4, P103 and P120 are
adjusted.
♦ During the n/f controller optimization P115 = 5, the parameters
P116, P223, P235, P236, P240 and P471 are determined.
In principle, automatic parameterization (P115 = 1) or motor
identification (P115 = 2, 3) should be carried out as soon as one of the
following parameters are adjusted in the converter status "Drive setting"
(P060 = 5):
P068 = Output filter
P095 = Motor type
P097 = Motor number
P100 = Control type
P101...P109 = Motor rating plate data
P339 = Release of modulation system
P340 = Pulse frequency
P357 = Sampling time
Operating Instructions
P295 P337
P303 P339
P306 P344
P313 P347
P315 P348
P316 P388
P319 P392
P322 P396
P325 P471
P326 P525
P334 P536
P335 P602
P336 P603
Parameterizing Steps
9-63