Parameter Reset To Factory Setting - Siemens simovert masterdrives Betriebsanleitung

04.2006
9.1

Parameter reset to factory setting

Siemens AG 6SE7087-6KD60
SIMOVERT MASTERDRIVES
The factory setting is the defined initial state of all parameters of a unit.
The units are delivered with this setting.
You can restore this initial state at any time by resetting the parameters
to the factory setting, thus canceling all parameter changes made since
the unit was delivered.
The parameters for defining the power section and for releasing the
technology options and the operating hours counter and fault memory
are not changed by a parameter reset to factory setting.
Parameter number
P050
P070
P072
P073
P366
P947
P949
Table 9-1 Parameters which are not changed by the factory setting
If the parameters are reset to the factory setting via one of the
parameters (SST1, SST2, SCB, 1.CB/TB, 2.CB/TB), the interface
parameters of that interface are not changed either. Communication via
that interface therefore continues even after a parameter reset to the
factory setting.
Parameter number
P053
P700
P701
P702
P703
P704
Table 9-2 The factory setting is made either via interface SST1 or SST2:
Parameters that are not changed by the factory setting either. None of
the indices of the parameters is changed.
Operating Instructions
Parameterizing Steps
Parameter name
Language
Order No. 6SE70..
Rtd Drive Amps
Rtd Drive Power
Select FactSet
Fault memory
Fault value
Parameter name
Parameterization enable
SST bus address
SST baud rate
SST PKW number
SST PZD number
SST frame failure
9-3