Siemens simovert masterdrives Betriebsanleitung Seite 290

Parameterization
8-26
With the "OP: Download" function, a parameter set stored in the OP1S
can be written into the connected slave. Starting from the basic menu,
the "OP: Download" function is selected with "Lower" or "Raise" and
activated with "P".
P
VectorControl Download
*Menu Selection *1909199701
OP: Upread MASTERDRIVES VC
#OP: Download
Example: Selecting and activating the "Download" function
One of the parameter sets stored in the OP1S must now be selected
with "Lower" or "Raise" (displayed in the second line). The selected ID
is confirmed with "P". The slave ID can now be displayed with "Lower"
or "Raise" (see section "Slave ID"). The "Download" procedure is then
started with "P". During download, the OP1S displays the currently
written parameter.
P
Download Download
*1909199701 *1909199701
MASTERDRIVES VC MASTERDRIVES VC
Example: Confirming the ID and starting the "Download" procedure
With "Reset", the procedure can be stopped at any time. If downloading
has been fully completed, the message "Download ok" appears and the
display returns to the basic menu.
After the data set to be downloaded has been selected, if the
identification of the stored data set does not agree with the identification
of the connected unit, an error message appears for approximately 2
seconds. The operator is then asked if downloading is to be
discontinued.
P
Download Download
*1909199701 *1909199701
MASTERDRIVES VC MASTERDRIVES VC
Yes: Downloading is discontinued.
No: Downloading is carried out.
P
VectorControl 00
Download
Pxxx
P 2 s
Error:
Different
IDs
6SE7087-6KD60
Operating Instructions SIMOVERT MASTERDRIVES
04.2006
VectorControl 00
Stop download?
#yes
no
Siemens AG