Siemens simovert masterdrives Betriebsanleitung Seite 294

Parameterizing Steps
NOTE
9-4
Parameter number
P053
P696
P700
P701
P702
P703
P704
Table 9-3 The factory setting is made via interface SCB2: Parameters that are not
changed by the factory setting either. None of the indices of the
parameters is changed.
Parameter number
P053
P711 to P721
P722
P918
Table 9-4 The factory setting is made either via interface 1.CB/TB or 2.CB/TB:
Parameters that are not changed by the factory setting either. None of
the indices of the parameters is changed.
Parameter factory settings which are dependent on converter or motor
parameters are marked with '(~)' in the block diagrams.
Parameter name
Parameterization enable
SCB protocol
SST bus address
SST baud rate
SST PKW number
SST PZD number
SST frame failure
Parameter name
Parameterization enable
CB parameters 1 to 11
CB/TB frame failure
CB bus address
6SE7087-6KD60
Operating Instructions SIMOVERT MASTERDRIVES
04.2006
Siemens AG