Checking The Brakes; Replacing Lamps; Checking The Speed Sensor - dutch id PHANTOM Bedienungsanleitung

Regularly check the tyres of the e-bike for wear. If the tread in the middle of the tyre is no longer
visible, the tyre must be replaced. When checking the tyre, also check for cracks. If you observe
deformations in the tyre, the tyre is worn and must be replaced. Contact your Dutch ID dealer
for the correct replacement parts.
8.2.3.

Checking the brakes

A decrease in braking force may be caused by:
Ҍ Worn brake blocks. If the brake blocks have a thickness of less than 0.5 mm, they must be
replaced. Have this done by a Dutch ID dealer.
Ҍ Air in the brake lines. It may also be necessary to bleed air out of the brake cables to rectify a
reduction in braking force. Have this done by a Dutch ID dealer.
Ҍ Defective brake line. Check for leaks in the brake line. This affects the braking force and must
be repaired. Have this done by a Dutch ID dealer.
Ҍ Check the brake lines for damage or excessively sharp bends. The brake lines must not be
kinked or crushed, as this affects the braking force of the bike.
8.2.4.

Replacing lamps

When replacing the lamps, check that the lamps are compatible with the Bosch e-bike system
and that they have the correct voltage. In the event of broken or defective lighting, contact a
specialised Dutch ID dealer.
NOTICE
Make sure the old lamp is replaced with a lamp with the same voltage.
8.2.5.

Checking the speed sensor

Check that the speed sensor is mounted properly. The spoke magnet and the speed sensor must
be mounted at the same height. The space between the speed sensor and the spoke magnet
must be between 5 and 17 mm.
If necessary, the spoke magnet can be positioned correctly as follows:
1. Loosen the screw on the spoke magnet.
2. Slide the spoke magnet until the magnet is aligned with the marking on the speed sensor.
3. Tighten the screw on the spoke magnet.
Contact a Dutch ID dealer if you have problems reading the speed on your on-board
4
computer.
90