Installing And Removing The On-Board Computer - dutch id PHANTOM Bedienungsanleitung

A
Figure 14 - Inserting the charging plug into the battery.
The power unit of the e-bike does not operate while the battery is being charged in the
4
battery holder.
Once the battery is fully charged, all battery level LEDs b
off.
5. Disconnect the charger l from the battery k.
6. Disconnect the charger
7.
Close the cap of the battery holder v
If you do not disconnect the charger after charging, the charger will automatically turn on
4
again after several hours, check the battery level and begin charging again if necessary.

4.6. Installing and removing the on-board computer

1. Install the on-board computer
2. Pull the underside of the on-board computer towards you and click the underside in the
holder on the handlebars.
Figure 15 - Installing the on-board computer.
72
from the power supply.
l
(only when charging in the e-bike).
with the top in the holder on the handlebars.
4
B
and the on-board computer will turn
Figure 16 - Clicking the on-board computer into
place.