Warnings And Error Messages; Error Display On The On/Off Button [18]; Error Display By The Leds [19] - Alber Erivo R10 Gebrauchsanweisung

6. Warnings and error messages

6.1. Error display on the On/Off button [18]

If an error occurs when the system is switched on, the LEDs on the LED display [19] light up in succession from left to right.
The error that has occurred is indicated by the On/Off button [18], which flashes red. The number of consecutive flashes means as follows:
Number of Error
signals
1 Joystick error
2 Network or configuration error
3 Left-hand motor error
4 Right-hand motor error
5 The left-hand motor is in push mode
6 Both motors or only the right-hand
20
motor are/is in push mode
7 Module error

6.2. Error display by the LEDs [19]

In addition to the error messages listed in chapter 6.1, other errors are indicated by the LED display [19] as follows:
LED signals
Remedy
Check whether the joystick was outside of its mid-position when the sys-
tem was switched on. Switch off the Erivo, ensure that the joystick is in its
mid-position, then switch the Erivo back on.
If the error continues to be displayed, please contact your specialist dealer.
Please contact your specialist dealer.
Please contact your specialist dealer.
Please contact your specialist dealer.
Switch the left-hand motor to electric motor operation (see chapter 2.1)
Switch the right-hand motor to electric motor operation (see chapter 2.1)
Please contact your specialist dealer.
Error
All LEDs are illuminated; the two green LEDs are
flashing.
High voltage warning
The red LED flashes.
Low voltage warning
The red LED is flashing and a warning signal
sounds every 10 seconds.
Cut-off voltage
The left, middle and right LEDs flash.
Unlocking the system
All LEDs flash.
Safety function to prevent the Erivo inadvert-
ently moving off (caused by the deflected joy-
stick) when the system is switched on.
All LEDs light up briefly in succession, from left to
right in each case.
Travelling gear inhibition
Remedy
The battery voltage level has increased.
Please contact your specialist dealer.
Charge the battery immediately.
Charge the battery immediately.
The system is locked.
Switch the Erivo off and on again. Ensure that
the joystick [16] is in its mid-position.
The joystick [16] is not located in its mid-position.
Switch the Erivo off and on again. In doing so,
ensure that the joystick [16] is in its mid-position.
Count the number of signals on the On/Off but-
ton [18] (see table in chapter 6.1) and remedy the
error.