Starting Up A New Saw Chain; Maintaining The Chain Bar; Turn The Chain Bar - Parkside PKSA 20-Li C3 Originalbetriebsanleitung

saw chain and the guide rail may not
be more than 2 mm.

Starting up a new saw chain

In the case of a new chain, the tensioning
force decreases after some time. Therefore,
you have to re-tension the chain after the
fi rst 5 cuts and no later than after 10 min-
utes' sawing time.
Approved saw chains:
Oregon 90PX040X,
Trilink CL14340TL,
Trilink CL15040BL,
Trilink CL14340BL.
Never attach a new chain to
a worn drive pinion or place
onto a damaged or worn
chain bar. The chain could
spring back or break, poten-
tially leading to serious injury.
Maintaining the chain
bar
Use cut-protection gloves
when handling the chain or
the chain bar.
1. Switch off the device and remove the
battery (16) from the device.
2. Remove the sprocket chain wheel cov-
ering (12), the saw chain (7) and the
chain bar (8).
3. Check the chain bar (8) for wear. Re-
move burrs and straighten the guide
surfaces with a fl at fi le.
If the blade bar is damaged, repla-
ce it. Approved blade bars:
Oregon 575271,
Trilink M1431040-1041TL.
4. Clean the oil passages (
the chain bar, in order to guarantee a
trouble-free, automatic oiling of the saw
chain during operation.
5. Mount chain bar (8), chainsaw (7) and
sprocket chain wheel covering (12)
and tighten the chainsaw.
With the oil nozzles in good condi-
tion and the oil regulator set cor-
rectly, the saw chain will spray a
little oil off after starting.

Turn the chain bar

Use cut-protection gloves when han-
dling the chain or the chain bar.
The blade (8) has to be reversed regularly
after a working time of approximately 10
hours in order to ensure even wear.
1. Switch off the device and remove the
16) from the device.
battery (
2. Remove the sprocket chain wheel cov-
ering (12), the saw chain (7) and the
chain bar (8).
3. Turn the blade around its horizontal
axis and install the blade and chain as
described under "Installing the sawing
chain and blade".
When doing so, pay attention to the cor-
rect rotation direction of the saw chain!
Use the graphical symbol below the chain
sprocket (20) as a guide to the alignment
of the saw chain (7) when the blade is ro-
tated. The illustrated direction of travel on
the blade is no longer true.
24), of
Direction of travel of the
saw chain
GB
55