Switching On; Battery Charge Level Indicator; Checking The Chain Brake - Parkside PKSA 20-Li C3 Originalbetriebsanleitung

GB
the electric chainsaw is in contact
with no objects.
Caution! Saw can oil up, see notes
on Operation startup.

Switching on

1. Place the battery (
device (see "Inserting/removing the
rechargeable battery").
2. Check before the start,
- whether suffi cient chain oil is in the
tank and, if necessary, refi ll with
chain oil (see Chapter Operation
Start).
- the charge status of the battery.
3. Release the chain brake, where you
shift the brake arm (6) back against the
front grip (5).
4. Hold the chainsaw fi rmly with both
hands, with the right hand on the rear
grip (1) and the left hand on the front
handle (5). Thumb and fi nger must
close securely over the handles.
5. For switching on, activate the switch-on
block (3) with the right thumb and then
press the On/Off switch (2), the chain-
saw runs with highest speed. Release
the switch-on block (3) again
6. The power saw switches off when you re-
lease the On/Off switch (2) again. Switch-
ing for continuous running is not possible.
Battery charge level
indicator
The battery's charge level is indicated by
the charge state indicator.
The LEDs indicate the battery's charge level,
when the device is in operation.To do this,
press the softkey of the charge level indicator.
48
16) into the
3 LEDs illuminated (red, orange and green):
Battery charged
2 LEDs illuminated (red and orange):
Battery partially charged
1 LED illuminated (red):
Battery needs to be charged
Checking the chain
brake
The motor cannot be turned on if the
chain brake has engaged. Do not
employ the chain brake in order to
start the chainsaw or to switch it off.
1. Place the chainsaw onto a solid, fl at
surface. It must not contact any objects.
2. Ensure that the chain brake has been
released, that is, that the chain brake
lever (6) is pulled up against the front
grip (5).
3. Hold the chainsaw fi rmly with both
hands, with the right hand on the rear
1) and the left hand on the
handle (
front handle (
must close securely over the handles.
4. Turn on the chainsaw.
5. Activate the chain braking lever (6),
with running motor, with the left hand.
6. Once the chain brake is working prop-
erly, release the on/off switch (2) and
the chain brake.
If the chain brake does not
function correctly, you must
not use the chainsaw. A slack
saw chain leads to danger of
injury. Return the chainsaw to
our Service-Center for repair.
5). Thumb and fi nger