Recharging The Battery; Assembly; Mounting The Saw Chain And Blade - Parkside PKSA 20-Li C3 Originalbetriebsanleitung

of contact with eyes or skin, rinse
the affected sites with water or a
neutralizer and seek medical atten-
tion.
The battery must only be charged
up in dry areas. The external sur-
face of the battery must be clean
and dry before being connected to
the charger. There is a risk of perso-
nal injuries from an electric shock.
To recharge batteries of the
( PARKSIde) X 20 V TEAM series,
only use a charger belonging to the
( PARKSIde) X 20 V TEAM series.
• Charge the battery before using it for
the fi rst time.
• Always comply with the latest safety
information, as well as the regulations
and information relating to environmental
protection.

Recharging the battery

Allow a hot battery to cool before
charging. Only charge the batte-
ry (16) when the red LED on the char-
ge status indicator is on.
1. Remove the battery (16) from the ap-
pliance, as necessary (see „Removing/
inserting the battery").
2. Insert the battery (16) in the charging
compartment of the battery charger (17).
3. Plug the battery charger (17) into a
mains outlet.
4. When the battery is fully recharged un-
plug the battery charger from the mains.
5. Remove the battery (16) from the char-
ger (17).
Overview of the control display on
the charger:
Green LED lights up without battery
inserted: Charger ready.
Green LED lights up:
Battery such alleged charged.
Red LED lights up: Battery charging.
Red LED fl ashes: Battery overheated
Red + green LEDs fl ash: Defective battery

Assembly

Always wear protective
gloves when working with
the chainsaw and employ
only original parts. Pull out
the power plug before doing
any work on the chainsaw
itself – injury hazard!
Before putting the electric chain saw into
operation, you must:
- adjust the saw chain tension,
- pour in chain oil,
- Charge and insert the battery
- check the function of the chain brake
and the automatic oil pump.
Mounting the saw chain
and blade
Switch off the device and remove
the battery before carrying out any
maintenance work.
1. Lay the saw on a fl at surface.
2. Turn the fastening bolt (10) anti-
clockwise (
sprocket chain wheel covering (12).
3. Spread the chain (7) out into a loop
with the cutting edges running clock-
wise . Use the graphical symbol on the
blade or below the chain sprocket (20)
as a guide to align the saw chain (7).
GB
) to remove the
45