Cleaning And Maintenance - Scheppach THM850 Originalbetriebsanleitung

• The knife is exactly set, when the ruler is moved by the knives not
higher than 3 mm.
• After a successful knife setting, all clamping screws must be tight-
ened (8.4 N/m).
Please mind:
• Sharp planer/thicknesser knives guarantee a clean planing surface
and put less stress on the motor.
• After three grinding actions, a maximum material removal of 3 x 0.05
mm may not be exceeded.
• The planer/thicknesser blades used on this machine are not suitable
for rebating and dovetailing.
• Finally lower the cutter block guard again onto the table. Cover the
cutter block and block it with the star grip screw.
m IMPORTANT!
Only use knives which are recommended by the manufacturer for this
equipment. If you use other knives there is a risk of injuries due to lack
of control.
Avoid over-tightening and the possibility of the thread becoming de-
tached. If the latch or the screws have worn out threads they must be
immediately replaced.

10. Cleaning and maintenance

m IMPORTANT! Before any cleaning, adjustment, maintenance or
repair work, disconnect the power plug from the main power supply!
Machine care
The planer/thicknesser requires little maintenance. The ball bearings
are permanently lubricated.
After approx. ten operating hours, lubrication of the following parts is
recommended:
• Bearing of the infeed and output roller
• Bearing of pulley and sprocket
64 | GB
www.scheppach.com