Scheppach THM850 Originalbetriebsanleitung Seite 65

The threaded spindle for height-adjustment of the thicknessing table
may only be treated with a dry lubricant agent.
The table surfaces as well as the infeed and output rollers must always
be kept free from resin.
• Regularly clean infeed and output rollers.
• In order to avoid overheating of the motor, regularly check the air
openings for any dust sticking on.
• After a longer period of use, it is recommended to have the machine
checked by an authorized dealer service.
Tool care:
• Cutter block, clamping devices, knife supports and knives must be
regularly cleaned from resin, as a clean tool improves the planing
quality. To this purpose, clamping devices, knife supports and knives
can be put in a common resin remover for 24 hours.
• Resin from aluminium tools may only be removed with cleaning liq-
uids not being aggressive to this type of metal.
Attention:
In case of a bad condition of the electrical system, the performance can
drop for a short period of time. Ask a specialist.
11. Storage
Wrap the power cord (29) around the cable holder (30) provided for this
purpose. For the sliding cane the sliding cane holders (28) are provided.
Store the equipment and accessories out of children's reach in a dark
and dry place at above freezing temperature. The ideal storage tem-
perature is between 5 and 30 °C.
Store the electric tool in its original packaging.
Cover the electrical tool in order to protect it from dust and moisture.
Store the operating manual with the electrical tool.
www.scheppach.com
GB | 65