Herunterladen Inhalt Inhalt Diese Seite drucken

Scheppach THM850 Originalbetriebsanleitung Seite 61

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

8.4 Chip extractor - thickness planing (fig. 11)
• The parallel stop (5) needs to be removed for thickness planing. Fol-
low point 8.1 in reverse order.
• Now slide the planing knife cover (7) beside so that the cutter block is
completely uncovered.
• Hold the switching pins (3) outside and set the chip extractor (4) on
top of the machine.
• Now lock the chip extractor (4) with the switching pins in the table.
Attention! The machine won´t start if the switching pins (3) are incor-
rectly plugged in.
9. Operation
m IMPORTANT!: The surfacing and thicknessing plane has been spe-
cially designed for planing solid wood. High alloy knives (24) are used for
this purpose. The contact surface of the workpiece must be flat for thick-
nessing. If you want to work on large or heavy workpieces, the machine
must be secured in place (e.g. using the thread in the machine base).
• The ON/OFF switch (1) is on the left-hand side of the machine. Press
the green key "I" to switch on the machine. Press the red key "0" to
switch off the machine.
• The machine is fitted with an overload switch (2) to protect the motor.
In the event of an overload, the machine will cut out automatically. Af-
ter a short time, the overload switch (2) can be reset again.
• To work on long workpieces, use roller tables or a similar supporting
arrangement. Such optional units are available from your local DIY
stores. They must be placed at the entry and exit ends of the plane.
Their height must be adjusted such that the workpiece is horizontal
when it is fed into and out of the machine.
9.1 Surfacing
m IMPORTANT!: Pull out the power plug before performing any main-
tenance, cleaning and adjusting work.
www.scheppach.com
GB | 61

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

5802201986

Inhaltsverzeichnis