Scheppach THM850 Originalbetriebsanleitung Seite 62

9.1.1 Adjustment (fig. 7/8)
• Turn the adjustment knob for cutting depth (11) to set the height of the
feed table (12). The set cutting depth can be read off the scale (A).
• Loosen the parallel stop (5) with the star grip nut (22). Set the required
angle.
The set angle can be read off the scale (B). Secure the parallel stop
(5) with the star grip nut (22) again after making the setting.
9.1.2 Surface planing mode (fig. 9/10)
Attention! Watch out the right mounting of the chip extractor (point 8.3)
• (Narrow workpieces, see fig. 9) Open the clamping screw (9) and
move the planing knife cover (7) only so far as the workpiece is wide..
Then tighten the clamping screw (9) again.
• (wide, flat workpieces see fig. 10) Open the star grip nut (6) and
set the planing blade cover cpl (13) just as high as the workpiece is
thick. The planer blade cover (7) covers the entire knife! Tighten the
star grip nut (6) again.
• Plug in the machines power cord. Press the green button "I" to start
the planing machine.
• Place the workpiece you wish to plane on the feed table (12). Slide the
workpiece as far as possible with the push stick (16) forwards towards
the planing table (26) over the knives (24).
• When you have finished work, switch off the machine. To do this, press
the red button "0". Then disconnect the machine from the mains supply.
• Remove the chips and dust from the feed table (12), planing table (26)
and knife block after the machine has reached a complete standstill.
• Bring back the planer blade cover (7) and cover the planer blade over
its entire length.
9.2 Thicknessing
m IMPORTANT!: Pull out the power plug before performing any main-
tenance, cleaning and adjusting work.
62 | GB
www.scheppach.com