Scheppach THM850 Originalbetriebsanleitung Seite 67

Important information
In the event of an overloading the motor will switch itself off. After a cool-
down period (time varies) the motor can be switched back on again.
Faulty electrical connecting leads
Insulation damage often occurs at electrical connecting leads.
Causes include:
• Pressure marks caused when connecting leads are run through win-
dows or the cracks of doors.
• Folds caused by the improper attachment of running of the connect-
ing leads.
• Cuts resulting from the crossing of the connecting lead.
• Insulation damages caused by the ripping out of the connecting lead
from the wall socket.
• Cracks due to the ageing of the insulation.
Faulty electrical connecting leads such as these may not be used and
are highly dangerous due to the insulation damage.
Check electrical connecting leads regularly for damage. Ensure that
the connecting lead is not attached to the mains supply when you are
checking it.
Electrical connecting leads must correspond to the relevant VDE and
DIN regulations. Only use connecting leads with the code H05VV-F.
The type designation must be printed on the connecting lead by regulation.
AC motor
• The supply voltage must be 230 volt ~ / 50 Hz.
• Extension leads up to 25 m in length must have a cross-section of
1.5 mm², > 25 m length / 2,5 mm².
Connections and repairs of electrical equipment may only be performed
by a qualified electrician.
Please give the following information if you have any enquiries:
• Type of current
• Machine type label data
• Data on the main label
www.scheppach.com
GB | 67