Assembly - Scheppach THM850 Originalbetriebsanleitung

• All covers and safety devices have to be properly fitted before the ma-
chine is switched on.
• It must be possible for the planing knife to run freely.

8. Assembly

8.1 Parallel stop (fig. 2)
• Turn out the locking bolt (17) a little bit clockwise. (The locking bolt
shouldn´t fall out)
• Now set in the locking bolt (17) into the slot of the sidewall of the par-
allel stop.
• Shove aside the parallel stop (5) so far that the slotted hole fit to the
screw (18) and can be lowered.
• Now you can tighten the Allen screw (18) with the enclosed Allen
wrench (14) and tight the locking bolt (17) counterclockwise.
8.2 Crank handle for thickness planer chip depth (fig. 3)
• The crank handle (10) will be only plugged on the spindle (19).
8.3 Chip extractor - surface planing (fig. 4-6)
• Set the planing knife cover cpl. (13) in the upperst position.
• Use the crank handle (10) to place the Thicknessing table (21) in the
lowest position.
• Take the chip extractor (4) and hold the switching pins (3) beside.
Place the chip extractor (4) at a slightly slanting angle on the machine
and push it backwards.
For this you need to hold the switching pins (3) outwards.
• Now lock the chip extractor (4) with the switching pins in the table.
Attention! The machine won´t start if the switching pins are incorrectly
plugged in.
• Now you can fold the planing knife cover cpl. (13) down again.
60 | GB
www.scheppach.com