Herunterladen Inhalt Inhalt Diese Seite drucken

Scheppach THM850 Originalbetriebsanleitung Seite 59

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Whilst the machine is running keep your hands at a safe distance from
the cutting block and from the point at which the chips are discharged.
Do not start the planing work until the cutting block has reached the
required speed.
Also ensure that the workpiece does not contain any cables, wires,
cords or the like. Do not machine any wood which has lots of knots or
knot holes.
Secure long workpieces to prevent them tipping over at the end of the
planing process. Use roller stands, for example, or similar devices for
this purpose.
Removing sawdust and chippings from the machine when running is
strictly prohibited.
Switch off the machine immediately it is jams. Pull out the mains plug
and remove the jammed workpiece.
Set the smallest cutting size after use to prevent the risk of injury.
m CAUTION!
The machine must be secured to the floor / countertop using suitable
screws / screw clamps since otherwise there is a risk that it will tip over.
• Before you connect the equipment to the mains supply make sure that
the data on the rating plate are identical to the mains data.
m WARNING! Before cleaning~, adjustment~, maintenance~ or re-
pair work, disconnect the power cord from the main power supply!
• Check at regular intervals that the knife (24) is firmly attached in the
knife block.
• The knives (24) must not project more than a maximum of 1.1 mm out
of the knife block.
• Make sure that the anti-kick claws (25) work correctly.
• Always wear eye protection.
• Never cut concavities, tenons or shapes.
www.scheppach.com
GB | 59

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

5802201986

Inhaltsverzeichnis