Detergents - Instructions; Preparing The Machine For Work; Working - Tennant CS16 Bedienungsanleitung

Detergents - Instructions

Always dilute the detergent according to the manufacturer's instructions. Do not use sodium hypochlorite
(bleach) or other oxidants, particularly in strong concentrations. Do not use solvents or hydrocarbons.
The temperature of the water and detergent must not exceed the maximum indicated in the technical
dryers.
For a complete and up-to-date list of the detergents and chemical products available, contact a dealer trained and
approved by the manufacturer.
Follow the safety precautions concerning the use of detergents given in the section "IMPORTANT SAFETY PRE-
CAUTIONS".

Preparing the machine for work

Before starting work, put on overalls, ear defenders, non-slip waterproof shoes, mask to protect the res-
piratory tract, gloves and all other personal protective equipment recommended by the supplier of the
detergent used or needed for the particular work environment.
Proceed as follows before starting work:
Check the battery charge level (recharge if necessary);
Fill the detergent tank by way of the opening at the front (
water and low-foam detergent at a suitable concentration. Leave a gap of at least 5 cm between the water and low-foam detergent at a suitable concentration. Leave a gap of at least 5 cm between the
surface of the liquid and the mouth of the tank; surface of the liquid and the mouth of the tank;
Make certain that the squeegee is securely fastened and connected to the suction hose; check that the Make certain that the squeegee is securely fastened and connected to the suction hose; check that the
wiping edges are not worn. wiping edges are not worn.
Adjust the working height of the squeegee. Adjust the working height of the squeegee.
and obstacle-free area to acquire the necessary familiarity with the functions and controls. and obstacle-free area to acquire the necessary familiarity with the functions and controls.
Prepare the work area by removing all possible obstacles;
Begin working from the point farthest away, to avoid walking on the area that has just been cleaned;
Keep the working passes as straight as possible;
mop or rag.

Working

Having set up the machine, proceed as follows:
function can be activated (see the "Controls - Descriptions" section);
necessary;
! WARNING!
! ATTENTION
! NOTICE ! NOTICE
, follow these simple rules:
EN
-
23