Battery: Installation And Connection; Selection Of Battery Charger; Battery: Removal - Tennant CS16 Bedienungsanleitung

The various items of packaging can be kept, if so desired, as these can be reused to protect the machine in the
If not retained, the packaging must be disposed of in compliance with current regulations.

Battery: installation and connection

Follow the instructions given below exactly as described, bearing in mind that if the battery is short-cir-
The operation of installing or removing the batteries must be carried out by trained personnel.
Position the battery on the machine using lifting equipment able to handle its weight.
Connect the wiring terminals to the battery, observing the correct polarity (+ / –), tighten and smear
with vaseline.

Selection of battery charger

When recharging the battery, use only the battery charger supplied by the manufacturer of the machine.

Battery: removal

The operation of installing or removing the batteries must be carried out by trained personnel.
When removing the batteries, the skilled technician must make use of such personal protective equip-
ment (gloves, eyewear, overalls, safety shoes, etc.) as is needed to reduce the risk of accidents. Make
Disconnect the battery cable terminals from the battery poles.
Lift the batteries from the compartment using suitable handling equipment.
! DANGER
check the battery charge by sparking.
cuited, there is a risk that it could explode.
! DANGER
Contact Tennant for battery advice.
! WARNING!
! ATTENTION
! DANGER
Contact Tennant for battery advice.
! DANGER
smoke. Proceed as follows:
EN 20