Mounting And Changing The Brush/Drive Disks Drive Disks; Detergents - Instructions; Preparing The Machine For Work - Tennant CS16 Bedienungsanleitung

Mounting and changing the brush/drive disks
During brush/drive disk attachment and release, pay attention to brush rotation. During brush/drive disk attachment and release, pay attention to brush rotation.
Never work without the brushes and drive disks correctly installed. Never work without the brushes and drive disks correctly installed.
Brush/drive disk attachment:
of the machine by levering on the handle, then lower it onto the brush, centring it with the brush cover. Operate
is not successful, press on the handle again and repeat the centring and repeated operation of the brush lever.
Brush/drive disk release:
After a few pulses, the brush (or drive disk) is released and falls to the ground.

Detergents - Instructions

Always dilute the detergent according to the manufacturer's instructions. Do not use sodium hypochlo-
rite (bleach) or other oxidants, particularly in strong concentrations. Do not use solvents or hydrocar-
bons. The temperature of the water and detergent must not exceed the maximum indicated in the techni-
driers.
For a complete and up-to-date list of the detergents and chemical products available, contact one of the manufac-
turer's trained and authorised dealers.
Follow the safety precautions concerning the use of detergents given in the section "IMPORTANT SAFETY PRE-
CAUTIONS".

Preparing the machine for work

Before starting work, wear overalls, ear protectors, non-slip waterproof shoes, mask to protect the res-
piratory tract, gloves and all other personal protection devices recommended by the supplier of the deter-
Proceed as follows before starting work.
water and low-foam detergent. Leave at least 5 cm between the surface of the liquid and the opening of water and low-foam detergent. Leave at least 5 cm between the surface of the liquid and the opening of
front and rear blades are not worn. front and rear blades are not worn.
adjust the working height of the squeegees. adjust the working height of the squeegees.
drive disks
DANGER DANGER
WARNING WARNING
WARNING
WARNING
gent used or necessitated by the work environment.
IMPORTANT! IMPORTANT!
EN 25