At The End Of Work; Some Useful Tips For Getting The Most Out Of The Machine; Draining The Dirty Water - Tennant CS16 Bedienungsanleitung

suction motor when the tank is full. If the switch should be tripped while the machine is in use, suspend
operations and empty the tank;
minimum charge level; a few seconds more, and operation of the brush and suction functions will be

At the end of work:

At the end of work:
uous pressure could result in deformation of the wiping edges;
Remove the brush (or pad drive board) to avoid the risk of permanent deformation occurring;
Empty and clean the dirty water tank.

Some useful tips for getting the most out of the machine

in two separate stages.
Prewash with brushes or pads:
Begin washing.
which the solution is released must be set to suit to the speed at which the operator chooses to proceed.
The slower the machine moves forwards, the less water is needed.
Persist when washing particularly dirty areas, so that the detergent has time to perform its chemical
action.
Drying:
Lower the squeegee and, with the suction motor switched on, pass over the area scrubbed previously.
The result will be equivalent to that of a deep cleansing scrub, and subsequent routine maintenance
operations will take less time.

Draining the dirty water

Draining the dirty water
Use personal protective equipment appropriate for the work being carried out.
The dirty water tank drain hose is at the back of the machine on the right.
To empty the tank:
Position the machine near a drain;
horizontally;
Keeping the end of the hose as high as possible, remove the cap;
from the ground;
Check the amount of dirt left in the dirty water tank and, if necessary, wash the inside of the tank;
Close the drain hose with the cap, check that it is perfectly tight, and return the hose to its housing.
The machine is now ready to wash and dry as before.
! ATTENTION
a few seconds more, and operation of the brush and suction functions will be
! DANGER
EN
-
24