Fitting and adjusting the squeegee
Fitting and adjusting the squeegee
Proceed as follows to install:
Proceed as follows to install:
checked frequently.
For perfect drying, the squeegee must be adjusted in such a way that the edge of the rear blade bends during
Moving the machine when not in operation
To move the machine, proceed as follows:
the machine to the new location;
Fitting and changing the brush/pad drive boards
During brush/pad drive board attachment and release, pay attention to brush rotation.
During brush/pad drive board attachment and release, pay attention to brush rotation.
Never work without the brushes and pad drive boards correctly installed.
Never work without the brushes and pad drive boards correctly installed.
Fitting the brush/pad drive board:
the front end of the machine by pulling back on the handle, then lower the scrubber head directly onto the brush,
steps of aligning the brush and jogging the control lever.
Releasing the brush/pad drive board:
After a few pulses, the brush (or pad drive board) is released and falls to the ground.
brush/pad drive boards
! DANGER
! DANGER
! WARNING!
! WARNING!
EN
22