Adjusting The Handle Rake Angle; Fitting The Brush/Pad Driver; Brush/Pad Driver Release; Battery: Preparation / Installation / Recharging - Tennant CS5 Bedienungsanleitung

Adjusting the handle rake angle

the desired angle. Releasing the lever, the handle will remain locked in
the position selected.

Fitting the brush/pad driver

•
•
•
• Pull back on the handle to elevate the front part of the machine,
position the brush cowling directly over the brush, and proceed to
•
operation is not successful, reposition the machine as before, then
repeat the steps of aligning the brush and jogging the control lever.

Brush/pad driver release

•
• Pull back on the handle to elevate the front part of the machine
•
seconds; the machine will activate the brush release mechanism
automatically.

Battery: preparation / installation / recharging

• Use only batteries supplied by the manufacturer
code), as other types of battery could explode, causing injury
to persons and damage to property.
•
• DO NOT smoke near battery or charger.
• DO NOT charge the battery outdoors.
• DO NOT expose the battery to temperatures above 100°C /
212°F.
• Charge the battery at a temperature between + 4°C / 39.2°F and
+ 40°C / 104°F.
• NEVER leave the battery in enclosed areas, such as in cars
on hot days, where temperatures can be much higher than the
outside temperature.
• DO NOT attempt to repair or modify the battery or battery
charger, contact Tennant for any issues.
• DO NOT short circuit the battery or charger terminals with
conductive objects such as paper clips, the battery may ignite
or explode.
• DO NOT crush, drop, incinerate or damage the battery.
• DO NOT use a damaged battery in any way.
! DANGER
EN
2
(BAAC00196
1
Fig.9
1
Fig.10
1
Fig.11
Fig.12
13