Start-Up With Emergency Supply Set - GOK BHK 052 OPSO Montage- Und Bedienungsanleitung

OPSO / UPSO: If very long pipes are installed at the outlet of the product, it
may be necessary to pull out and hold the spindle
seconds until pressure compensation is achieved.

START-UP WITH EMERGENCY SUPPLY SET

Connecting a gas cylinder with emergency supply set; double-stage tank regulator
type BHK 052 or type BHK 052B
close
1. Close the gas withdrawal valve on the
overfill sensor on the gas tank.
close
3. First screw the emergency supply
connector on to the emergency supply
set and then connect it with the gas
cylinder (spanner width 30).
7. Check the connections on the gas cylinder and on the emergency supply for leaks
(spray with a foaming agent acc. to EN 14291 (leak detector spray, Part no. 02 601 00).
When the gas tank has been refilled, dismantle the emergency supply set in the
following sequence:
1. Close the cylinder valve.
2. Loosen and remove the connections of the emergency supply set.
3. Screw the sealing nut of the emergency supply connector on again tightly.
4. Carry out LEAK CHECK..
If you open the withdrawal valve or the gas cylinder valve too quickly, this can result in a
short-term pressure increase that triggers the overpressure shut-off device (OPSO).
If the visual indicator switches to RED during start up, do the following:
• Allow a few short bursts of gas to escape from the connected device to equalise the
pressure.
• If the pressure does not equalise and the OPSO cannot be unlocked
(visual indicator remains RED), the pressure regulator must be replaced.
Artikel-Nr. 05 288 50 m
Behälterregler-Kombination PS 25 bar
2.
close
4. open
4.
5.
6.
with release device
open
Unscrew the sealing nut of the
emergency supply with a suitable open-
end spanner (width 19).
5.
Open the cylinder valve.
Press the start-up button of the excess
flow valve.
START-UP OPSO / UPSO.
for several
27 / 182