Operation; Cleaning And Care; Disposal - Parkside PWS A1 Bedienungs- Und Sicherheitshinweise

Note: At this point, first check the size of
the handle thread of your angle grinder. It
may be M6, M8 or M10.
Then place the corresponding mounting bolts
, washers and matching nuts
8 7
tance pieces and plastic bushings
10
one side, ready for use.
Insert the necessary plastic bushings
the mounting pieces
11
Note: Ensure that the size of the plastic
bushings matches the required mounting
6
bolts . Plastic bushings are not required
8
for mounting bolts M10
Place the desired distance piece
washer on the mounting bolt
7
Fig. 7).
Note: The three distance pieces
choosing the most appropriate cutting depth.
Note: Set the distance piece
cutting disc cannot come into contact with
the workbench / table below the base plate
(see Fig. 7).
20
Screw the matching mounting bolt
the mounting pieces
11
grinder by wrench
29
Fasten the angle grinder in place by tighten-
ing the corresponding size of nut
mounting bolt (i.e. by turning it in the
8
direction of the mounting piece pieces
(see Fig. 6).
26
Now set the adjustment screws
that the angle grinder is aligned at right an-
gles to the base plate
20
to the mount (see Fig. 6).
24
After slightly loosening the hexagonal socket
head screws , adjust the saddle
23
that the cutting disc of the angle grinder
lowers into centre of the slot provided in the
base plate (see Fig. 7).
20
Now attach the safety guard
push the safety guard
and fasten it in place with the wing nut
2
(see Fig. 8).
4
Now insert the metal rod
sponding opening in the mount
it in place with the wing screw
, dis-
9
to
6
into
6
, (see Fig. 5).
26
.
8
and
10
(see
8
are for
10
so that the
10
through
8
, and the angle
26
(see Fig. 6).
on the
9
,
11
, so
1 13
and firmly attached
so
21
. To do this
5
on to the metal rod
5
into the corre-
2
and fasten
24
(see Fig. 8).
27
Always keep the angle grinder's mains lead
in place using the clip
After assembly is complete, switch the angle
grinder on for a few seconds and then
switch it off again. Check again that all the
screws, bolts and fixings are firmly seated.

Operation

Adjust the guide bolts
piece placement.
Place the workpiece on to the base plate
against the rear stop
rotating rotary adjustment knob
Note: Ensure that the workpiece lies
against the base plate
CAUTION! DANGER OF INJURY! En-
sure that the length of the workpiece is at
least half the length of the stop
wise the workpiece may become loose and
slide out.
Set the vice stops
17
piece lines up with the centre of the cutting
disc.
Now switch on the angle grinder and press
it down on to the workpiece.
Avoid any backwards movement
and apply even pressure on the
workpiece.

Cleaning and care

Use a slightly moist, fluff-free cloth when you
are cleaning or polishing the product.

Disposal

The packaging is made entirely of recyclable
materials, which you may dispose of at local
recycling facilities.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
product.
.
25
for desired work-
16
20
and secure it by
18
.
14
(see Fig. 9).
20
, other-
18
, so that the work-
18
GB/MT 35