Post-Seat/Horizontal Positioning Of The Saddle; Tightening Torques - SQlab M-D LINE Bedienungsanleitung

Post-seat/Horizontal Positioning of the Saddle

First mount the saddle in the center of the clamping range. Vary according to your needs starting from the center position within the
adjustment range to the front and back. You can find information on the correct adjustment of the saddle position in the instructions of
your bike and in a variety of books and guidebooks on the subject of bicycle ergonomics.
Your SQlab specialist dealer will certainly also be happy to help you.
Note
SQlab saddles should tend to be pushed slightly further forward than your previous saddle.

Tightening Torques

The tightening torque of the clamping bolts on the seat post depends on the seat post model. However, do not use a seat post where
the tightening torque of the bolts on the clamping of the seat stays is specified as more than 18 Nm according to the manufacturer.
Warning
Tightening torque outside the specified range
Risk of falling due to sudden and unmediated breakage of the saddle rail caused by deformation or necking.
•
Observe the specified tightening torque of the saddle clamp. in the operating instructions belonging to the seat post.
•
Never exceed the maximum tightening torque of 18 Nm. In the event of a conflict in the specifications of the tightening
torque, please contact your specialist dealer.
Warning
Clamping outside the specified range.
Risk of accident due to sudden and unmediated breakage of the saddle
rail during use.
• Clamp your SQlab saddle only within the scale shown on the
saddle rails.
•
In the case of a longer lower clamp jaw, make absolutely sure
that the saddle rail is not deformed when tightening.
❌ NOT OK