Assembly; Tools; Angle Of The Innerbarends - SQlab Innerbarends 410 Bedienungsanleitung

Tools

Name
SQlab Innerbarends 411 R Carbon
®
SQlab Innerbarends 411 / SQlab Innerbarends
®
SQlab Innerbarends ® 410/ 402
Warning
Incorrectly assembled components pose a considerable risk.
• You must have read and understood the instructions and notes before you start the

assembly.

• If you have questions about the assembly of these components, please contact
your SQlab dealer or have your Innerbarends® either checkedor mounted by an
experienced bicycle mechanic.

Angle of the Innerbarends

Basic setting: The clamping screw points
vertically downwards, from there you can
adapt the angle depending on the seat
angle and saddle elevation.
When the saddle is higher than the hand­
lebars tilt the innerbarends forward. When
the saddle is lower than the handlebars tilt
the Innerbarends® towards the rider.
Warning
Under no circumstances should the Innerbarends® be adjusted too flat or too steep.
If they are set too flat, you can slip off very easily. If the Innerbarends® are set too
steep the wrist bends too much, resulting in increased compression of the nerves.
hex key
4
411 ltd. RUH 5
®
5
®
Tightening torque (Nm)
5
3
5
Innerbarend