Assembly of the pedals
The scope of delivery of the SQlab pedals basically consists of two pedals. The SQlab pedals 502/ 511 also the necessary Cleats are in
cluded in the scope of delivery. The SQlab Pedals 512 come with two cleats, two pedals, six cleat adapters and six screws for mounting
the cleats
Read the user information for the crank and pedals carefully before installation. If there are any questions, doubts or contradictory spe
cifications, please ask your SQlab dealer for advice before installation.
Warning
Incorrectly installed components pose a considerable risk:
• You must follow and understand the instructions and no
tes in the operating manual before you start with the as
sembly.
• If you have questions about the installation of these com
ponents, contact your SQlab dealer or have your SQlab pe
dals assembled by an experienced mechanic at your SQlab
dealer.
For the assembly of the pedals, in addition to assembly and me
chanical basic knowledge, a 6 mm hex key and a corresponding
torque wrench is required. For the adjustment of the release force
a 3 mm hex key is needed. For mounting the Cleats you need a
4mm hex key.
Caution
For the equipment of an eMTB, ebike and pedelec you need
to observe partly countryspecific standards, rules and regu
lations.
• In Germany, please refer to the „Leitfaden für Umbauten
an Pedelecs" of the ZweiradIndustrieVerband e.V. (http://
www.zivzweirad. de/) in cooperation with the Verbund Ser
vice und Fahrrad g.e.V. (www.vsf.de) and Zedler Institute for
Bicycle Technology and Safety GmbH (www.zedler.de).
• The SQlab pedals have NO blanket approval for fast pe
delecs (Spedelecs, up to 45 km/h).