Mounting Compatibility And Operating Safety - SQlab M-D LINE Bedienungsanleitung

Category 3 according to DIN EN 17406
Refers to bicycles and EPACs to which condition 1 and condition 2 apply, and which are also used on rough
paths, uneven unpaved roads, as well as difficult terrain and undeveloped paths, and for which technical skill
is required. Jumps and drops shall be less than 60 cm.
Average speed in km/h
Maximum drop/jump height
Intended use
Bike type
Category 3 according to ASTM F2043-13
Bikes/attachments in this category can be used on rough trails, rough terrain and difficult routes that require
good riding technique, in addition to the conditions of use specified in categories 1 and 2. Jumps and drops
can occur here up to a maximum height of 61 cm.
Warning
Exceeding the individual load limit of the components
Risk of falling due to breakage of the components
Adhere to the permissible system and rider weight.
•
Use your saddle only in the intended use category or in a lower use category (according to ASTM F2043-13/DIN EN
•
17406).
Make an extraordinary inspection after situations with particularly or unexpectedly large force impact, such as after a fall,
•
riding error or an accident.
In case of doubt, the possibly damaged component should be replaced prophylactically. In such a case, better play it safe
•
and ask your SQlab dealer for advice.
Note
For the protection of third parties, a component that is not immediately and obviously recognizable as defective should be clearly
marked as unusable.

Mounting Compatibility and Operating Safety

The saddles of the SQlab M-D Line have generally common round rails with a diameter of 7 mm made of a metallic alloy. These can be
mounted with few restrictions on most standard seatposts.
The principle of operation, the clamping forces and the quality of workmanship especially of the contact surfaces and edges of the
seatpost can affect the durability of the saddle or its seat frame and possibly damage it.
Therefore, never mount your SQlab M-D Line saddle on unsuitable seatposts, but only on seatposts that meet the criteria below:
Note
Always also observe the notes and warnings provided in the installation and operating instructions that come with your seatpost.
✓ OK
The clamping of the struts must have a length "A" (or support distance) of at least
32 mm. The minimum length "B" and "C" of each clamping surface must be at least
7 mm.
irrelevant
< 60 cm
Sport & competition riding
Cross-Country & Marathon bikes