Technical Features - Bartscher 900-Serie Bedienungsanleitung

appliances in the room may modify the balance of the gas supply in the room. That means that
appliances may be fed with gas at lower gas pressure and rate than those provided for and they
may give worse performance.
The following instructions for set up and functioning refer to gas and mixed appliances belonging to
categories I , II
3B/P 2H3+
(G30- G31) of 30/37 mbar, for Methane (G20- G25) of 20/25 mbar, and for Town Gases (G110-
120) of 8mbar. The data plate (fig. 9-11 – pag.6-7) with all the information to refer to regarding the
appliance, is situated inside the right or left side of the control panel, depending on the model.
The appliances have been checked in accordance with the European directives below.
2006/95/EC
CEE 2004/108
2009/142/CE (ex 90/396/CEE)
2006/42/CE
2011/65/UE
And the particular reference norms.
Declaration of compliance
The manufacturer declares that the appliances of their production are compliant with the above
mentioned EEC directives and requires that installation be done observing the norms in force,
regarding particulary the system for letting out fumes and air exchange.
Gas cooking top
Sturdy structure in steel, placed on four feet which make it possible to regulate the height, in the
version with cabinet. The outer finishing is stainless steel. Each number on the cooking top has a
safety gas cock which makes it possible to regulate the output from maximum to minimum; safety
is ensured by a thermocouple which is kept active by the flame of the pilot burner.
The burner, the Venturi tube, the gas rings and the grills are made from a fusion of cast-iron.
Electric cooking top
Sturdy structure in steel placed on four feet which make it possible to regulate the height in the
version with cabinet. The outer finishing is stainless steel. Each hotplate on the hob has a pressure
switch which makes it possible to vary the heat output from minimum to maximum in seven
positions; safety is ensured by a temperature limit-switch situated inside the hotplate.
The elctric hotplate is in cast iron with the heating element fixed on the bottom, embedded in a
layer of insulating material.
All hotplate
Sturdy structure in steel placed on four feet which make it possible to regulate the height. The outer
finishing is stainless steel. It has a safety gas cock, enabling regulation of the output from maximum

TECHNICAL FEATURES

, II , II , III
2H3B/P 2HS3B/P
- Low Tension (LVD)
- Electromagnetic Compatibility (EMC)
- Gas Appliances
- Machine Rules
- Rohs
DESCRIPTION OF APPLIANCES
Pag. 63/100
with a power pressure for Buthane/Propane
1ab2H3B/P