MAVIG Portegra2 Installationsanleitung Seite 6

Important Safety and Precautionary Comments
It is strongly recommended that at least two persons perform the installation.
Installing the system: Prior to installation, MAVIG emphasizes that a structural engineer must certify that
the rough ceiling is strong enough to provide proper support for the entire system and any attached end
devices. Installation must be completed according to local building codes. Failure to follow these procedures
will release MAVIG from responsibility for damages of any sort.
Determination of required installation hardware and torque values for installation of the ceiling column
and ceiling track is the sole responsibility of the structural engineer.
Ceiling mounted systems must be installed properly. Failure to follow the instructions provided may lead
to a potentially dangerous and unstable condition of the system.
This product must be serviced with MAVIG approved, original replacement parts. Failure to follow this
recommendation will void the manufacturer's warranty and will release MAVIG from all liability and
warranty claims.
When installing and adjusting the Portegra2 and/or associated components, ensure
to cut off the power supply to the entire system. Danger of Death!
removal, or repair of Portegra2 parts that have electrical components.
!
The Portegra2 spring arm is under constant spring tension. When installing and
removing devices to and from the spring arm, always raise it up slowly to the
upper stop. Failure to follow this instruction will void the manufacturer's warranty
and release the manufacturer from all liability and warranty claims.
The system must only be operated by trained personnel. It is essential to have personnel understand
that collisions of the system with other equipment can lead to severe damages, and failure of system.
The Portegra2 system is only validated and approved by MAVIG for the following CE-­devices: radiation
protective shields, monitor display holders, injector holders, and Dr. Mach OR and examination lights.
Portegra2 must not be combined with suspension systems from other manufacturers.