Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
9.0
NOTE:
It is strongly recommended that at least two people perform the installation.
!
Only a non-electrical extension/spring arm combination can be mounted to the lower
mounting post.
9.2.1
Loosen the 3 set screws (1/Fig. 21) and carefully slide the locking ring (2/Fig. 21) off the
mounting post (3/Fig. 21).
9.2.2
Remove the lock screw (4/Fig. 21) from the locking ring (2/Fig. 21).
9.2.3
Remove the protective cap from the mounting post (3/Fig. 21).
Store screws (1,4/Fig. 21), locking ring (2/Fig. 21) and both washers (5,6/Fig. 21) for re-use.
NOTE: If the two plastic halves of the arm cover (7/Fig. 21) are already connected, gently separate them.
extension arm, onto the 360° mounting post (3/Fig. 21).
9.2.6
Connect the end of the safety chain (8/Fig. 21) with the locking ring (2/Fig. 21).
9.2.7
Apply Loctite
270 to the lock screw (4/Fig. 21) and tighten it into the locking ring (2/Fig. 21)
®
9.2.8
Mount the locking ring (2/Fig. 21) with the two washers (5,6/Fig. 21) on the 360° mounting post.
9.2.9
Apply Loctite
270 to the 3 set screws (1/Fig. 21) and secure the locking ring (2/Fig. 21) to the
®
9.2.10
Remove the arm cover (7/Fig. 21) from the ceiling column shipping carton. Use this instead of
the arm cover supplied with the Portegra2 extension/suspension.
9.2.11
Place the speed nut (10/Fig. 21) on the screw hole tab of the the arm cover. Attach the two
click the snaps into the grooves.
!
When mounting or removing covers again, be very careful as the snaps can break off.
This can cause the covers not to stay in place, and can fall on patient during procedures.
!
Make sure that the cover's screws (9/Fig. 21). are not screwed too tight, stripping the
thread of the cover. Replace the cover if the screw hole has been stripped.
9.2.14
Insert and tighten the mounting screw (9/Fig. 21) into the thread provided.
Installation of the extension/spring arm combination
29
Werbung
Inhaltsverzeichnis
