NOTE:
It is strongly recommended that at least two people perform the installation.
Cut off all electricity prior to performing any works on the system - hazardous situation!
NOTE 01: The M130 has the transformer built into the lamp housing, no additional
NOTE 02: All other halogen lights have external transformers, which need to be
NOTE 03:
!
Ensure that the arm used is electrical and has an electric socket in the front and end of
the arm. Otherwise, no electricity can reach the end device.
!
Set the upper stop of the spring arm to the horizontal position (Position B/Fig. 26) during
the installation process. To correct this, insert an 5 mm allen wrench into the opening
(1/Fig. 27) and turn it fully to the right, otherwise the spring arm will uncontrollable
swing upwards.
transformer is necessary!
Installation and removal of adaptable elements