Operation Modes; System Settings - ECOLAB Lubo-DryExx Advanced AB Betriebsanleitung

6.3.7.1 Displays of Parameter Generaly
Fig. 6.13
After leaving the picture with button „Back "you see again the "Main Screen".

6.3.7.1.1 Operation modes

Fig. 6.14
After leaving the picture with button „Back "you see again the „General Parameters".
6.3.7.1.2 Monitoring
Fig. 6.15
6.3.8

System settings

Fig. 6.16
417102248_DryExx_Advanced_AB
The display contains the following announcements:
• Time relief pump
• Time pre tension system
• Time delay of empty signal
• Pulse value of optional oval gear meter (OGM)
• To change variables
 press variable
• To go to "operation mode"
 Press "operation mode"
• To leave "Parameter Generaly"
 Press 'Back'
OR
• To go to the 'Start' screen:
 Press "X"
The display contains the following announcements:
• Active operation mode
• To change operation mode
 Press desired operation mode button
 Switch on control dosing amount
• To leave "Operation mode"
 Press 'Back'
OR
• To go to the 'Start' screen:
 Press "X"
The display contains the following announcements:
• Actual metering value
• Desired metering value
• Metering deviation positive [%]
• Metering deviation negative [%]
• Metering value positive [%]
• Metering value negative [%]
• To the other valves (metering circuits)
 Press „" Button
 Press „" Button
• To configure the desired metering value
 Press „"
"System settings"
• To go to the
Press "Ecolab"

- 38 - Rev.: 2-01.15