Messages - ECOLAB Lubo-DryExx Advanced Betriebsanleitung

7.3.4.1.1.3 Parameter display: Change Separate Booster-function
fig. 7.14
After leaving the picture with button „Return" you see again the Parameter - „Valve and Booster-
times".
7.3.5

Messages

fig. 7.15
417101634_Lubo-DryExx_Advanced
The picture shows the following items:
 Circuit and area number (area)
 Total valve number of the system
 Waiting time for activation (default and actual)
 The time until the Booster-funktion will be
activated
 This time is running, if the release signal is off
• Active time (default and actual)
 The time how long the Booster-function is active
if finished the normal pulse- and break- time will
be used
• Actual status „Activation"
 This signal will be active if the time „After" is
running down
• Pulse- and break time (default)
 This times are used if:
1. The waiting time „After" is down
2. The release signal is „ON"
3. The active time „For" ist running
Information:
• This function is „ON" if both times „After" and „For"
are more than „0"
• This function is „OFF" if both times „After" and „For"
are „0"
 Change parameters:
 Press Values and input value (Password)
 Leave the picture:
 Press Button "Return"
OR
• To go to the 'Start' screen:
 Press " "
 To go to the "Messages"
 Press "Message"
- 45 - Rev. 07-01.15