VOLTCRAFT VC272 Bedienungsanleitung Seite 72

12.5.1 Follow the steps below to measure DC currents (A
1. Switch on the DMM and select "10A, mA, or µA" mode.
2. Press SEL/
3. Press the SEL/
4. Select the desired measurement range and connect the corresponding termi-
nals.
Measurement mode
µA
mA
10A
5. Insert the red test lead into the mAµA or 10A max measurement socket.
6. Insert the black test lead into the COM measurement socket.
7. Connect the two measuring probes (de-energised) in series to the object that
you want to measure (e.g. battery or circuit). The electrical circuit must be dis-
connected before you connect the probes.
8. Reconnect the circuit. The measurement will appear on the display.
9. After measuring, disconnect the circuit and remove the test leads from the
measured object. Switch the DMM off.
72
to switch to DC mode. "DC" will appear on the display.
button again to switch back to AC mode.
Measurement range
0 - 6000 µA
6000 µA - 600 mA
600 mA - 10 A
Terminals
COM + mAµA
COM + mAµA
COM + 10A
)