Disposal And Recycling; Troubleshooting - Scheppach Ke 70m Anleitung

17. Disposal and recycling

On removal of the machine the local legal regulations have to be abided by.
Please contact the manufacturer in case of disposal.
Old devices must not be disposed of with household waste!
This symbol indicates that this product must not be disposed of together with domestic waste in compliance with
the Directive (2012/19/EU) pertaining to waste electrical and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This can occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical and electronic equipment. Improper handling of waste equip-
ment may have negative consequences for the environment and human health due to potentially hazardous substanc-
es that are often contained in electrical and electronic equipment. By properly disposing of this product, you are also
contributing to the effective use of natural resources. You can obtain information on collection points for waste equip-
ment from your municipal administration, public waste disposal authority, an authorised body for the disposal of waste
electrical and electronic equipment or your waste disposal company.

18. Troubleshooting

Switch off the machine to rectify any faults. Pull out the mains plug!
Problem Possible Cause
Saw blade gets loose Fastening nut tightened insufficiently
after turning off the
motor
Motor does not start. 1. Failure of mains fuse.
2. Extension cable defective.
3. Connections at the motor or switch
out of order
Incorrect motor rota- Incorrect connection
tion direction
Motor does not work, 1. Overload due to blunt saw blade.
the fuse responds 2. Thermal protection tripped.
Decreasing saw power Belt loose
at full speed
m Electrotechnical maintenance works should only be carried out by an electronics technician!
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Help
Tighten fastening nut, right-handed thread
1. Check the mains fuse.
2. Check extension cable, do not continue to use
defective cables, have them repaired by a profes-
sional.
3. Check with the help of an electrician
Rotate phase
1. Insert sharpened saw blade.
2. Switch back on again after cool-down time.
Retighten belt
GB 29