Troubleshooting - Scheppach 5905112902 Originalbetriebsanleitung

Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an author-
ised collecting point for the recycling of waste electri-
cal and electronic equipment.

16. Troubleshooting

In the interests of operational safety, always switch off the saw and remove the mains plug before carrying out
maintenance work.
Problem
Saw blade gets loose after
turning off the motor
Motor does not start
Wrong rotational direction
No motor output, turns off
automatically
Burns on the cutting
surface
Possible cause
Fastening nut tightened insufficiently
failure main fuse
extension cable defect
connection to the motor or switch defect
Changed phase
cross section of extension cable is too
low
overload by dull saw blade
Dull saw blade
wrong saw blade
www.scheppach.com
Improper handling of waste equipment may have neg-
ative consequences for the environment and human
health due to potentially hazardous substances that
are often contained in electrical and electronic equip-
ment. By properly disposing of this product, you are al-
so contributing to the effective use of natural resourc-
es. You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equip-
ment or your waste disposal company.
Help
Tighten fastening nut, M20 left-handed
thread
Check the mains fuse
Replace the extension cable
Have to be checked by an electrician
Change the phase (see fig. 10)
See "electrical connection"
Insert a sharpened saw bladen
Insert a sharpened saw blade
Insert correct saw blade
GB | 29