Troubleshooting - Scheppach HS110 Original Bedienungsanleitung

Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment.

16. Troubleshooting

Fault Possible cause
Blade dissolves after To slightly tightened fastening nut
switching off the en-
gine
Engine will not start Failure mains fuse
Defective extension cable
Connections on motor or switch not in
order
Motor or switch faulty
Motor will not work, Cross section of the extension cable does
not sufficienty
the fuse is active
Overload by a blunt saw blade
Blunt saw blade
Fire marks on the
cutting surface
Wrong saw blade
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Improper handling of waste equipment may have
negative consequences for the environment and hu-
man health due to potentially hazardous substances
that are often contained in electrical and electronic
equipment. By properly disposing of this product, you
are also contributing to the effective use of natural
resources. You can obtain information on collection
points for waste equipment from your municipal ad-
ministration, public waste disposal authority, an au-
thorised body for the disposal of waste electrical and
electronic equipment or your waste disposal compa-
ny.
Remedy
Tighten the right hand thread nut
Check mains fuse
Replace extension cord
Repair by electrical specialist
Repair by electrical specialist
see „Electrical connection"
Change saw blade
Sharpen saw blade (only by an authorised
sharpening service) or replace
Change saw blade
GB | 37