Setting The Rotational Speed; Working With The Leaf Blower - Parkside PLS 2600 A1 Originalbetriebsanleitung

2. Connect the machine to the power sup-
ply.
3. To switch the device on, slide the On/
Off switch (3) to position "I" of "II".
4. To switch the device off, slide the On/
Off switch (3) to position "0".

Setting the rotational speed

1. Slide the On/Off switch (3) to position
"I" for the lowest speed.
2. Slide the On/Off switch (3) to position
"II" for the highest speed.
Working with the leaf
blower
The leaf vacuum/blower may
only be used for the follow-
ing purposes:
- As a blower to pile up dry
leaf material or to blow ma-
terial out of places that are
hard to access (e.g. under
cars)
- As a suction device to suck
up dry leaf material. The
device also functions as a
shredder in the suction func-
tion. The dry leaves are
shredded and their volume
is reduced, preparing the
material for later compost-
ing if desired. The shredding
intensity depends on the size
of the leaf material and its
residual moisture. Uses other
than those described here
may damage the machine
and put the operator at risk.
During work, ensure that the device
is not struck against hard objects,
which can cause damage. Do
not suck up any solid bodies such
as stones, branches or pieces of
branch, fir cones or similar, since
these can damage the device, in
particular the shredding mecha-
nism. Repairs of this type are
not covered by the guaran-
tee.
Blowing operating mode:
You can operate the device without
a collection bag in the blowing
mode.
• You get optimal results when you use
the blower with a separation distance
to the ground of 5 -10 cm.
• Begin work with the highest blowing
power, in order to rapidly pile up the
leaves lying around. Select a lower
blowing power to compact the previ-
ously piled up leaves.
• Before blowing, loosen leaves adher-
ing to the ground with a broom or
rake.
• The guide rollers at the end of the tube
make it easier to work on flat surfaces.
• Always hold the device tight with both
hands during operation: use the handle
( 4) and the additional handle
( 2) for this
Suction operating mode:
For safety reasons, all tube
sections and the collection
bag must be correctly mount-
ed before you can start the
device.
• Always hold the device tight with both
hands during operation: use the handle
( 4) and the additional handle
( 2) for this.
GB IE NI
15