Information About Saw Blades; Before Use; Mounting / Replacing Saw Blades; Rotating The Hand Grip - Parkside PFS 710 A1 Originalbetriebsanleitung

General safety advice for electrical power tools / Before use / Preparing for use
recommended in the operating instructions
could lead to you suffering an injury.

Information about saw blades

Q
You can use any saw blade as long as it has the
correct shank fitting - /
1
2
There are different saw blades available in various
lengths designed to ensure optimum performance
of every sawing task with your sabre saw.
Note: TPI = teeth per inch / (i.e. per 2.54 cm)
Blade (wood) :
11
Dimensions: 152 x 1.25 mm, 6 TPI
Most suitable for: Sawing construction timber,
chipboard, processed wood boards, plywood.
Also suitable for plunge cuts.
Bi-metal saw blade
Dimensions: 156 mm, 18 TPI
Most suitable for: Sawing sheets, profiles and tubes
– flexible and fracture resistant.

Before use

Q
Mounting / replacing
Q
saw blades
Pull the mains plug out of the
mains socket before you carry out any task on the de-
vice. Failure to observe this advice may lead to injury.
j
T urn the quick-release chuck
the turned position.
j
P ress the selected saw blade up to the stop
into the quick-release chuck
should engage.
j
R elease the quick-release chuck
must then return to its original position. The saw
blade is now locked in place.

Rotating the hand grip

Q
DANGER oF INJURy! Pull
the mains plug out of the socket before you carry
out any task on the device. The hand grip
be rotated by 90° to the right or left. This allows
10 GB/IE
" (12.7 mm) universal shaft.
:
12
and hold it in
7
. The saw blade
7
. The chuck
7
can
4
the ON / OFF switch
3
comfortable position for any working conditions.
j
P ress the unlocking button
hand grip to the right or left.
4
j
M ake sure the hand grip

Adjusting the shoe

Q
DANGER oF INJURy! Pull
the mains plug out of the socket before you carry
out any task on the device.
j
A djust the shoe
5
j
T o do this release the shoe adjustment lever
and place the shoe
j
L ock the shoe in this position by pulling the
shoe adjustment lever

Setting the blade speed

Q
The desired blade oscillation speed can be prese-
lected by using the setting wheel
oscillation speed, + = highest oscillation speed).
The blade speed can also be selected whilst you
are using the device.

Preparing for use

Q

Switching on and off

Q
When operating the device you can select between
intermittent or continuous operation mode.
To switch on intermittent operation mode:
j
P ress the ON / OFF switch
To switch off intermittent operation mode:
j
R elease the ON / OFF switch
To switch on continuous operation mode:
j
P ress the ON / OFF switch
pressed position with the lock button
to be brought into the most
and rotate the
10
engages.
4
to suit the cutting depth.
in appropriate position.
5
tight.
8
(– = lowest
1
.
3
.
3
and fix it in the
3
.
2
8