Parkside PLS 2600 A1 Originalbetriebsanleitung Seite 11

• Damaged cables, coupling and
plugs or connecting leads not
corresponding to specifications,
must not be employed. Remove
the plug immediately from the
plug socket in case of damage
to the mains cable. Do not touch
the mains power supply cable
under any circumstances until
you have pulled the plug out of
the mains socket.
• Extension cables are to be kept
away from dangerous moving
parts to prevent damage to the
cable, which could lead to con-
tact with live parts.
• Ensure that the in-feed is empty
prior to starting the machine.
• Keep your face and body away
from the in-feed aperture.
• Do not allow hands or other
body parts or clothing to enter
the in-feed or discharge chute,
or to be in the vicinity of moving
parts.
• Ensure you are standing se-
curely and do not lose your bal-
ance. Avoid an abnormal work
posture. When material is being
taken in by the machine, never
stand on a higher level than the
base of the machine.
• Do not stand within the ejection
zone while operating the ma-
chine.
• Take extreme care when feeding
material into the machine to en-
sure no metallic objects, stones,
bottles, canisters or other for-
eign objects are taken in.
• Do not allow processed mate-
rial to accumulate in the ejec-
tion zone since this can prevent
proper ejection and cause the
material to be brought back into
the machine via the in-feed ap-
erture.
• If the machine becomes
clogged, turn off the power
source and disconnect the ma-
chine from the mains supply
before freeing any refuse.
• Never operate the machine with
defective protective equipment
or shields, or without safety
equipment, e.g. without the col-
lection bag being connected.
• Keep the power source free of
refuse or other accumulated
material to prevent it from be-
coming damaged and avoid a
potential fire.
• Do not transport the machine
while the power source is run-
ning.
• If the cutting mechanism comes
into contact with a foreign
object or the machine starts to
emit unusual noises or vibrate,
immediately turn off the power
source and wait for the machine
to come to a standstill. Discon-
nect the machine from the mains
supply and perform the follow-
ing steps before re-starting and
operating the machine:
- Investigate for damage;
- Replace or repair damaged
parts;
- Check for loose parts and
tighten as necessary.
• Do not tilt the machine while the
power source is running.
• Ensure that you do not connect
a damaged cable to the power
supply or touch a damaged
cable before it has been discon-
nected from the power supply
GB IE NI
11