Switching On And Off / Setting The Speed Range; Using The Grip Collar With Led Light; Advice On Working With Materials / Tools / Speed Ranges - Parkside PMGS 12 C3 Bedienungs- Und Sicherheitshinweise

operation
Using the Insertion tool with mandrel
NOTE: Use the screwdriver end of the combi-
nation key to release or tighten the screw of
23
the mandrels .
13
I nsert the mandrel
described.
W ith the aid of the combination wrench
unscrew the screw from the mandrel
P lace the insertion tool you wish to have onto
the screw between the two washers.
W ith the aid of the combination wrench
tighten the screw on the mandrel
Switching on and off /
Q
Setting the speed range
Switching on / Setting the speed range:
C onnect the plug
2
by inserting it into the plug-in device
for such purposes (see Fig. A).
C onnect the device to the power supply by
inserting the mains plug into the socket.
Slide the oN / oFF switch
between "5000" and "20000".
Switching off:
Slide the oN / oFF switch
position.
Using the grip collar
with lED light
Hold the spindle lock
clamping nut from the thread, turning coun-
5
ter-clockwise.
Release the spindle lock
Then unscrew the grip collar
thread, turning counter-clockwise.
Screw the grip collar with LED light
thread, turning clockwise.
Hold the spindle lock
ing nut onto the thread, turning clockwise.
5
Release the spindle lock
56 GB/MT
into the electrical tool as
13
23
.
13
23
.
13
to the power supply unit
provided
8
to a position
1
to the "oFF"
1
and unscrew the
7
.
7
from the
4
onto the
6
and screw the clamp-
7
.
7
:
Set the oN / oFF switch of the LED light
13
position "I" to switch it on.
Set the oN / oFF switch of the LED light
position "0" to switch it off again.
Repeat the steps in reverse order to reattach the
grip collar
,
Advice on working with
Q
materials / Tools / Speed ranges
,
U se the highest speed when working on steel
or iron with the milling bits
U se a short trial on a test piece to determine the
optimum rotational speed range for working on
zinc, zinc alloy, aluminium, copper and lead.
U se the low speed range for working on plastics
and low-melting point materials.
U se high speeds on wood.
10
U se the medium speed range for cleaning,
polishing and buffing.
The following information shall be considered as
recommendatory only. Learn by practical experience
which tools and settings are the best for the materi-
als you work with.
Setting the appropriate speed:
Numeral on the
rotational speed
control
1
5000
9000
13000
17000
20000
.
4
.
20
Material to be
worked on
Plastics and low melting
point materials
Stone, Ceramics
Softwood, metal
Hardwood
Steel
to
24
to
24